TRC option TANGENTIAL_LIMIT

This option is available as of CNC Build V2.11.2835.

This parameter can affect the operating principle of motion blocks inserted by the TRC for almost tangential transitions. Inserted blocks by the TRC are regarded as tangential up to the transition angle (180 degrees + TANGENTIAL_LIMIT).

A reduction in the limit results in a stronger deceleration response at corresponding transitions. A reduction in limit is not recommended when contouring methods are used, e.g. Polynomial contouring (G261).

Syntax:

#TRC [ [TANGENTIAL_LIMIT=..] ]

TANGENTIAL_LIMIT=..

Defining additive limit for tangential transition consideration

Value range: 0.1 to 3 degrees

Default value is 3

;Transition angles up to 181.5 degrees considered as tangential transitions

#TRC[TANGENTIAL_LIMIT=1.5]