Additional functions

The # commands listed below may not be programmed in configured 2-path programming. If programmed, error message (ID 21595) is output.

• #AKIMA ..
• #CAX ..
• #CYL
• #CYL OFF
• #CONTROL AREA ..
• #ECS ..
• #MCS ..
• #MCS TO WCS
• #WCS TO MCS
• #FACE ..
• #HSC ..
• #ROTATION ..
• #SPLINE ..
• #TOOL ORI CS

All # commands may only be programmed in a separate NC block in 2-path programming. Error message (ID 21594).is output if a specific path is programmed in the same NC block.