General drive parameters
Additional information
- Handling of drive command position (P-AXIS-00123)
- Handling of drive actual position (P-AXIS-00122)
- Time base for normalisation of velocity (P-AXIS-00207)
- Normalisation of the velocity
- Delay between command value and actual value (P-AXIS-00191)
- Positioning operation mode of an axis (P-AXIS-00320)
- Number of the latch input used for edge banding (P-AXIS-00353)
- Ignore unknown entries in drive telegram (P-AXIS-00358)
- Maximum time delay for disabling drive after a PLC watchdog error (P-AXIS-00367)
- Name of the EtherCAT master process (P-AXIS-00372)
- Encoder, used for CNC controlled homing (P-AXIS-00388)
- Base value for scaling of acceleration feedforward (P-AXIS-00392)
- Encoder resolution via feed constant numerator (P-AXIS-00362)
- Encoder resolution via feed constant denominator (P-AXIS-00363)
- Offset between drive position and CNC position for absolute encoders (P-AXIS-00403)
- Factor to coarse encoder resolution (P-AXIS-00405)
- EtherCAT-Fieldbus: Number of permissible telegram failures (P-AXIS-00406)
- Bit number for control of a DC brake (P-AXIS-00410)
- Number of probing input in drive (P-AXIS-00430)
- Use of position lag calculated in drive (P-AXIS-00466)
- Maximum time for drive reset (P-AXIS-00484)
- Drive without support for probing state (P-AXIS-00524)
- Activate evaluation of encoder position with additional mask (P-AXIS-00527)
- Drive encoder modulo range (P-AXIS-00528)
- Mechanical movement distance outside the software limit switches (P-AXIS-00459)
- Additional datum to calculate power_state_r
- Disabling drive controller for position lag error (P-AXIS-00537)
- Disabling drive controller in case of bus error (P-AXIS-00542)