Deselecting Akima spline interpolation (#SPLINE OFF)

Release Note

As of Build V2.11.2010.02 the command #SPLINE OFF replaces the command #SET SPLINE OFF. For compatibility reasons, this command is still available but it recommended not to use it in new NC programs.

Deselecting Akima spline interpolation is only permitted if at least 3 vertices were programmed or after 2 vertices if all tangents were specified (tangential transition at both ends of the curve or explicit programming of all tangents).

If the command is programmed in one statement together with a position, the respective point is not part of the Akima spline curve.

Alternatively, Akima spline interpolation can be selected using the G150 command.