ID 13187

Measured radii for S0 and S180 are different

Description

The measured spindle adjusting ring radii S=0 and S=180 are different and the difference is greater than the maximum permissible deviation @P5 or, if it was not parameterised, it is greater than 0.05mm. The measurement is not reliable.

Response

Class

-

Error: Transition to error state. Complete reset of the NC channel necessary.

Solution

Class

-

Check the probe and ring for soiling and clean if necessary.Check ring attachment to the table. Check the probe or probe tip attachment.

Error type

1, Error message from the NC program