ID 60198

Spindle speed too small for auto. link factor calculation.

Description

When the spindle-path coupling is activated with automatic calculation of the coupling factor (NC command S[FEED_LINK ON ..]), the current spindle speed is less than 1*10^-12 um/s.

See also [PROG// Section: Spindle feed link (FEED_LINK)]

This may be caused by the spindle speed programmed in the NC program or by an override or feedhold via the HLI.

Response

Class

6

Program abort.

Solution

Class

6

Check override or change program; at the time of activation of the spindle-path coupling, the spindle speed must be higher.

Parameter

%1:

Logical axis number (P-AXIS-00016) of the spindle

%2:

Current value [1µm/s or 0.001°/s]

Current spindle speed.

%3:

Limit value [1µm/s or 0.001°/s]

Permissible minimum value.

Error type

1, Error message from NC program.