ID 90036

Tool radius at channel block sequence circle-circle too large.

Description

No intersection was detected in the tool radius compensation at the block transition between two arcs to calculate parallel paths.

 

Since the tool radius was selected too large, one of the two equidistant circles lies inside the other circle.

 

Close the parallel path by using contour masking (G141) and this error is not output.

Response

Class

2

Abort NC program processing.

Solution

Class

6

Possible solutions are:

  • Use a tool with smaller radius
  • Adapt the programmed circles
  • Use contour masking (G141)

Parameter

%1:

Current value [0.1 µm or 0.0001°]

Difference between distance of centre points and difference between radii R1 and R2

%2:

Upper limit value [0.1 µm or 0.0001°]

Permissible tolerance for difference

Error type

1, Error message from NC program.