ID 90125

Length of the selection block with inner corner selection is less than tool radius.

Description

The length of the linear motion block after the inner corner selection of TRC is less than the tool radius.

The reason for this is the position of the point where the TRC was selected. This point is too close to the programmed contour.

Response

Class

2

Abort NC program processing.

Solution

Class

6

Check and modify the position of the point where the TRC is selected.

Parameter

%1:

Block number [-]

Number of the block where TRC is selected.

%2:

Error value [-]

Length of the selection block.

%3:

Lower limit value [-]

Minimum length of selection block.

Error type

1, Error message from NC program.