ID 90134

The coordinate of the corrected centre is outside of the permissible range.

Description

The tool radius compensation calculates coordinates of the equidistant course .

The error occurs when the coordinate of the calculated termination point exceeds the permissible range of data format.

The exceeding of the data format also occur with one in the tool radius compensation generated transition block, if its corrected termination point exceeds the data format.

Example:

When cutting 2 linear channel blocks with extremely small angle between the blocks, the intersection of the equidistant ones can deviate extremely far from the original programmed intersection, in extreme cases crosses it the limit value of the permissible range.

Response

Class

2

Abort NC program processing.

Solution

Class

6

Check and modify the NC program

Parameter

%1:

Error value [-]

Calculated coordinate

%2:

Lower limit value [0.1 µm or 0.0001°]

%3:

Upper limit value [0.1 µm or 0.0001°]

%4:

Block number [-]

Corresponding block number in NC program

%5:

Logical axis number [-]

Logical axis no.

Error type

1, Error message from NC program.