ID 120207

Inadmissible parameter in parameter setting of polynomial contouring.

Description

An invalid contouring parameter was programmed in the parameter setting for polynomial contouring (G61, G261).

Problem can only occur when using old syntax!

For more information on polynomial contouring, see[
PROG// Section: Polynomial contouring].

Response

Class

2

Program abort.

Solution

Class

6

Program correct parameter for contouring type, use new command syntax.

Parameter

%1:

Current value [-]

Current programmed contouring mode.

%2:

Lower limit value [-]

Minimum value for contouring mode.

%3:

Upper limit value [-]

Maximum value for contouring mode.

Error type

1, Error message from NC program.