ID 120433

While HSC function is active with mode 2 the programmed function is not supported.

Description

When the HSC function (#HSC[]) is active in spline mode, the following functions cannot be programmed.

- G100, measurement function.

- G95, feed rate per revolution.

- G61, G261 polynomial contouring

- G96, constant cutting speed.

- G33, thread cutting.

For more information on the HSC function
[PROG// Section: Standard HSC programming]

Response

Class

2

Program abort.

Solution

Class

6

Deselect the HSC function (#HSC[ OFF]) before programming the functions listed above

Error type

1, Error message from NC program.