ID 120463

Corner distance for iterative calculation of intermediate point too small.

Description

In polynomial contouring via functions G61, G261, the parameter of corner deviation or corner distance in the #CONTOUR MODE[] command is too small to calculate the polynomial contour line.

The error can also occur when the contour elements are near the resolution limit of the CNC. In this case, contouring cannot be used.

For more information on polynomial contouring, see [
PROG// Section: Polynomial contouring], FCT-D3].

Response

Class

2

Program abort.

Solution

Class

7

Depending on the mode, select a greater corner distance or corner deviation in the CNC command #CONTOUR MODE[].

Parameter

%1:

Incorrect value [0.1 µm or 0.0001°]

Detected corner distance.

%2:

Lower limit value [0.1 µm or 0.0001°]

Lower limit value for corner distance.

%3:

NC block number

First block of the transition.

%4:

NC block number

Second block of the transition.

Error type

1, Error message from NC program.