Spindle speed - path motion

The spindle must reach the programmed speed before a machining motion begins. The parameter P-CHAN-00081 (s_synch) defines a synchronisation type for speed.

Notice

The synchronisation method of the S function has no effect if a spindle M function is programmed in the same NC block. Synchronisation only takes place based on the settings for the spindle M function. The following priority sequence applies:

M19 > M3/M4/M5 > S

Example

1: Spindle asynchronous to path motion

spindel[i].s_synch  0x00000002 Output before, sync. before block

spindel[i].m3_synch 0x00000001 No synchronisation

N10 X0 Y0 G0

N20 X40 Y40 G1 F1500 M3 S500 ;Due to M3 no synchronisation

                             ;Motion starts immediately

N30 M3 S100 X0 Y0      ;Path executes motion without waiting

                       ;until spindle speed is reached

Example

2: Spindle synchronous with path motion

spindel[i].s_synch  0x00000002 Output before, sync. before block

spindel[i].m3_synch 0x00000001 No sync.

N10 M3 X0 Y0 G0

N20 X40 Y40 G1 F1500 S500 ;Path motion only starts when

                          ;spindle speed is reached

N30 S100 X0 Y0      ;Path waits before executing motion

                    ;until spindle speed is reached