General
A axis is the designation for the rotary axis about X.
B axis is the designation for the rotary axis about Y.
C axis is the designation for the rotary axis about Z.
Notice
The SysCalibConfigTouchprobe.nc file is not used for manual teach-in.
If no measuring signal is triggered during the measurement, the machine stops with the error message: “No workpiece detected, please check your measuring section.“
If a measurement is detected during positioning, the machine stops with the error message: “Collision on positioning, please check your motion range.“
The SysCalibConfigTouchprobe.nc file must be present and configured before the cycles are used, otherwise the cycles cannot run.
At the end of the cycles, a file is written CS_BASE_[CS ID @P39].bcs.
Attention
If the file already exists, it is deleted and a new file is written. No back-up is made!
From then on, the file can be called from any program.
The generated program defines the required coordinate system (CS) and enables it immediately.