Process (internal cycle)

  1. The touch probe must be positioned manually or in automatic mode in the proximity of the front left corner so that the probe can reach all points without collision.
  2. First execute 3 measurements on the top surface.
  3. Then execute the two measurements on the X surface.
  4. Finally, execute the two measurements on the Y surface.
  5. If a retraction height was transferred, the touch probe is retracted to this height.
  6. A new file is written CS_BASE_[CS ID @P39].bcs

Attention

attention

If the file already exists, it is deleted and a new file is written. No back-up is made!