Parameterisation

Required input parameters

Input parameters	Description
@P1	Reference plane (absolute)
@P2	Retraction plane (absolute)
@P3	Safety clearance in Z (relative to reference plane/machining height)
@P4	Depth (relative to reference plane)
@P5	Maximum infeed Z (unsigned)
@P6	Maximum infeed in XY (Maximum 2*V.G.WZ_AKT.R)
@P68	Pocket diameter

Input parameters	Description
@P7	Pitch of plunge helix with helical infeed in Z Default value = 10% of tool radius
@P8	Radius of plunge helix with helical infeed in Z Default value = 10% of tool radius
@P13	Safety clearance in the XY plane (relative to the pocket edge) Default value is 1/4 of the tool radius
@P15	Finishing allowance at base Default value = 0
@P16	Finishing allowance at edge Default value = 0
@P20	Feed rate for roughing for milling in the XY plane (specified in mm/min, inch/min)
@P21	Feed rate for roughing for infeed in Z (specified in mm/min, inch/min)
@P22	Feed rate for finishing for milling in the XY plane (specified in mm/min, inch/min) The default value is the feed rate for roughing
@P23	Feed rate for finishing for infeed in Z (specified in mm/min, inch/min) The default value is the feed rate for finishing for milling in the XY plane
@P30	Machining direction "ClimbMilling" or 0: Down milling (default) "UpCutMilling" or 1: Up milling
@P31	Machining mode: "Roughing" or 1: Roughing "Finishing" or 2: Finishing "Roughing+Finishing" or 3: Roughing and finishing (default value)
@P32	Feed mode in Z 1: Vertical 2: Helical (default value)
@P34	Machining path in XY 1: Helical (default value) 2: Circular with infeed in semicircle
@P40	Position of centre in X Default value is the current position
@P41	Position of centre in Y Default value is the current position

The function of the parameters acting in the XY plane is derived largely from the graphic below:

It is recommended to use the Syntax check.to verify whether the input parameters are correctly assigned.

Parameters which mainly refer to the Z axis are displayed in the graphic below: