Parameters
The touch probe must be configured in addition to supplying the input parameters described here. For more information on this function, see the section Configuration file.
The (calibrated) parameters of the touch probe (radius, length and offset in X and Y directions) are specified via the tool parameters.
Required input parameters
Input parameters | Description |
@P6 | Measurement path in the direction of the negative Z axis (unsigned) |
@P17 | Pre-position in X of the first measuring point relative to the start point |
@P18 | Pre-position in Y of the first measuring point relative to the start point |
@P39 | Select the required CS to be written. Value range: 1-10 |
@P41 | Pre-position in X of the second measuring point relative to the first measuring point |
@P42 | Pre-position in X of the third measuring point relative to the start point |
@P44 | Pre-position in Y of the third measuring point relative to the start point |
Optional input parameters
Input parameters | Description |
@P9 | Shift the measurement result along the 1st axis (shifts origin of the calculated coordinate system) Default value = 0 |
@P10 | Shift the measurement result along the 2nd axis (shifts origin of the calculated coordinate system) Default value = 0 |
@P11 | Shift the measurement result along the 3rd axis (shifts origin of the calculated coordinate system) Default value = 0 |
@P49 | Retraction height after measurement Default value = position after last measurement |
It is recommended to use the Syntax check.to verify whether the input parameters are correctly assigned.