General

The SysCalibConfigTouchprobe.nc calibration file must be present and the corresponding parameters must be configured before the cycles are used, otherwise the cycles cannot run.

If no measuring signal is triggered during the measurement, the machine stops with the error message: "No workpiece detected, please check your measuring section“ P-ERR-13413. If a measurement is detected while positioning the measuring motion during the cycle, the machine stops with the error message: “Collision on positioning, please check your motion range” P-ERR-13414.

The measurement results are saved in V.CYC. variables and can be processed in the post-files. An overview of existing output variables is contained in each of the cycle subsections.