ID 13462

A subroutine necessary for configuration cannot be called.

Description

A subroutine required for the cycle cannot be found in the configured program paths in the start-up list.

This may affect the following files

1. SysCalibConfigLaser.nc
2. SysCalibConfigLaserOn.nc
3. SysCalibConfigLaserOff.nc
4. SysCalibConfigToolSettingProbe.nc
5. SysCalibConfigTouchprobe.nc
6. NC filename for HSC settings- Deselection (P-CHAN-00470)
7. NC filename for HSC settings- Roughing (P-CHAN-00472)
8. NC filename for HSC settings- Prefinishing (P-CHAN-00474)
9. NC filename for HSC settings- Finishing (P-CHAN-00476)

Response

Class

-

Error: Transition to error state. Complete reset of the NC channel necessary.

Solution

Class

-

Check whether the subroutine exists and ensure that it is available in the configured program paths.

Parameter

%1:

Current value [-]

Sent value in the above list signals what file was not found.

Error type

1, Error message from NC program.