Parameterisation
Required input parameters
Input parameters | Description |
@P1 | Reference plane (absolute) |
@P2 | Retraction plane (absolute) |
@P3 | Safety clearance in Z (relative to reference plane/machining height) |
@P4 | Depth (relative to reference plane) |
@P5 | Maximum infeed in Z |
@P6 | Maximum infeed in XY (Maximum V.G.WZ_AKT.R is recommended to avoid residual material) |
@P35 | Reference cycle 1: SysMillContourPocket.ecy 2: SysMillContourSpigot.ecy |
@P36 | Tool radius used in the reference cycle |
@P50 | Identification number of the pocket or blank contour |
Optional input parameters
Input parameters | Description |
@P7 | Pitch of plunge helix Default value = 10% of tool radius |
@P8 | Radius of plunge helix Default value = 50% of tool radius |
@P15 | Finishing allowance at base in reference cycle Default value = 0 |
@P16 | Finishing allowance at edge in reference cycle Default value = 0 |
@P20 | Feed rate for roughing for milling in the XY plane (specified in mm/min, inch/min) |
@P21 | Feed rate for roughing in Z (specified in mm/min, inch/min) |
@P30 | Machining direction "ClimbMilling" or 0: Down milling (default) "UpCutMilling" or 1: Up milling |
@P32 | Feed mode in Z 1: Vertical (default value) 2: Helical |
@P51 | Identification number of an island contour |
@P52 | Identification number of an island contour |
@P53 | Identification number of an island contour |
@P54 | Identification number of an island contour |
@P55 | Identification number of an island contour |
@P56 | Identification number of an island contour |
@P57 | Identification number of an island contour |
@P58 | Identification number of an island contour |
@P59 | Identification number of an island contour |
@P60 | Identification number of an island contour |
Parameters which mainly refer to the Z axis are displayed in the graphic below:
It is recommended to use the Syntax check.to verify whether the input parameters are correctly assigned.
