Process

To ensure that the cycle is executed successfully, the following requirements must be met.

• The tool radius is defined by V.G.WZ_AKT.R (the tool radius is always specified at the face of the tool = 0)
• Tool length compensation is active.
• The spindle speed must be selected before the cycle is started.
• The workpiece edge to be deburred is reachable without collision at the height of the retraction plane
• All reference cycle parameters containing geometric descriptions of the milled object are transferred.

The workpiece is prepositioned within a cycle at the retraction plane. Then the tool is fed in Z with a slight offset to the workpiece edge before the required chamfer is produced by moving along the workpiece edge. To create a slight offset to the edge of the workpiece, you must either specify the machining depth (@P4) at a slightly greater depth than the bevel depth to be milled (@P101) or specify a radial tool offset to the edge of the workpiece (@P104).

The operation may vary slightly depending on the reference cycle used.