ID 50065

Remaining interpolation path greater than remaining braking distance.

Description

In the Edge banding function, the residual path P-CHAN-00030 defined in channel parameter list is reduced is reduced after activating the measurement signal using the measuring probe. The braking distance at speed 0 required at this point must be smaller than the residual path.

Note: The axis parameters P-AXIS-00001, P-AXIS-00002 and P-AXIS-00011, P-AXIS-00012 influence the braking distance.

For more information on edge banding see [PROG// Section: Edge banding (G108)].

Response

Class

1

Movement stop.

Solution

Class

1

Either increase P-CHAN-00030,

or reduce the programmed feed rate in the edge banding motion blocks,

or if possible increase the axis acceleration.

Parameter

%1:

Current value[0.1 µm or 0.0001°]

Required braking distance to velocity 0.

%2:

Expected value [0.1 µm or 0.0001°]

Residual path depending on P-CHAN-00030.

%3:

Current value[0.1 µm or 0.0001°]

Path distance of measurement actual positions and target positions.

%4:

Current value [1µm/s or 0.001°/s]

%5:

Current value[0.1 µm or 0.0001°]

Error type

1, Error message from NC program.