ID 60019

Programmed feed rate greater than maximum limit.

Description

In the tool parameters, dynamic limits can be defined for a spindle (see also [TOOL// Section: Dynamic and gear data]).

These limit values are accepted and, if necessary, the feed rate is adapted to these limit values if a D word (e.g. D17) is programmed in the NC program. After adopting the tool dynamic parameters, a check is carried out of the spindle feed rate against the maximum spindle feed rate.

This error message is output if the minimum spindle speed in the tool data (P-TOOL-00013) is greater than the maximum permissible axis velocity (P-AXIS-00212).

Response

Class

1

Spindle feed rate is limited to parameterised maximum feed rate and the program continues to run.

Solution

Class

1

Set the minimum spindle speed in the tool data (P-TOOL-00013) lower than the maximum axis velocity (P-AXIS-00212).

Parameter

%1:

Logical axis number (P-AXIS-00016) of the spindle

%2:

Current value [1µm/s or 0.001°/s]

Programmed feed rate.

%3:

Limit value [1µm/s or 0.001°/s]

Maximum feed rate.

Error type

1, Error message from NC program.