ID 70255

Axis is to be compensated, but a movement of the drive is not possible.

Description

One or several axis compensations are active for the affected axis. Its position must be corrected due to a position change of a master axis, However, the axis cannot move, since an axis-specific or channel-specific feedhold is set for the axis by the PLC.

[FCT-C5// Section: Overview]

Response

Class

7

Controlled stop of affected axis.

Solution

Class

5

Remove feedhold or turn axis compensation(s) off

Parameter

%1:

Logical axis number [-]

Logical axis number of the affected slave axis see P-AXIS-00016

%2:

Drive type [-]

Drive type of affected slave axis, see P-AXIS-00020

%3:

Block number [-]

Logical axis number of moved master axis P-COMP-00005, P-COMP-00014, P-COMP-00015

%4:

Logical axis number [-]

Block number of the NC program in the channel of the Master axis, in which the error occurred.

Error type

11, Error message from position controller.