ID 70285

Programmed function identifier in NC command #DRIVE not found.

Description

With a #DRIVE WR SYN [... KEY=XXX   VAL= ...] command, the programmed function identifier XXX was not found in the axis configuration data.

See [PROG// Section: Drive-independent switching of drive functions

Response

Class

7

Program abort.

Solution

Class

6

Adjust used function ID in the NC program or add the function ID used in the NC program to the configuration data.

Parameter

%1:

Logical axis number [-]

Logical axis number of affected axis, see P-AXIS-00016

%2:

Current value [-]

Unknown function ID value

detected programmed in KEY element

Error type

11, Error message from position controller.