Delay time for error message suppression with spindle tool revolution monitoring (P-AXIS-00787)

P-AXIS-00787

Delay time for error message suppression with spindle tool revolution monitoring

Description

For spindles, the axis parameters P-AXIS-00549/P-AXIS-00550 can activate a monitor for spindle actual speed against a parameterisable limit. If the limit is exceeded by ten percent, an error ERR-70376 is triggered and the spindle runs out.

At low speeds, it may occur that the 10% limit is undershot. The parameter P-AXIS-00787 specifies a delay time to delay the output of the error message if the spindle speed is lower than the speed set in P-AXIS-00788 .

If the actual speed of the spindle drops below the limit within the time specified in P-AXIS-00787, no error message is output. Above the limit speed specified in P-AXIS-00788 , an error message is output immediately.

If a value greater than the permissible delay time is configured in P-AXIS-00787, the warning ERR-110666 is output and P-AXIS-00787 is limited to the permissible maximum value.

Parameter

kenngr.v_limit_delay_time

Data type

UNS32

Data range

0 < P-AXIS-00787 < 500000

Axis types

S

Dimension

T: ----

S: µs

Default value

0

Drive types

SERCOS, Profidrive, CANopen

Remarks

This parameter is not available under TwinCAT.